SimXPro X80 Shifter Profile Bundle: Setup and Fitment FAQ

Quick answer

The SimXPro X80 shifter bundle pairs the X80 cockpit with a 58 cm extended shifter profile so you can place your shifter or handbrake where your arm naturally reaches, not where a short bracket forces it. Expect to spend time adjusting height and reach; the longer profile gives you room to get it right.

Setup and fitment questions answered

How do I set shifter mount height on the X80 bundle?

Mount your seat first, then sit in your normal driving position. Adjust the extended profile so the shifter knob falls naturally to hand without you leaning forward or shrugging your shoulder. A common starting point is roughly the same height as your steering wheel rim, but move it up or down until your wrist stays neutral through the throw. Finalize height only after the seat is in place; changing the seat later will shift your reference point.

Where should the shifter sit relative to the wheel?

For most sequential shifters, position the knob slightly behind and inboard of the wheel so your hand can leave the rim and return without crossing your body. If you also run a handbrake, place it outboard or lower so the two controls do not compete for the same hand path. Check reach with your arm fully extended, not just with fingertips.

Can I use the extended 58 cm profile for a handbrake instead of a shifter?

Yes, the profile is a mounting point, so it can carry a handbrake as long as your handbrake’s mounting pattern matches the slots or holes you have hardware for. Keep in mind that a tall, heavy handbrake at the end of a long profile may flex; add a brace or keep the profile short if you feel movement. Test for flex by pulling firmly on the handle before you finalize cable routing.

What tools do I need for assembly?

You will need the usual hex keys and wrenches for profile-based rigs, plus whatever hardware your shifter or handbrake uses. The bundle does not include shifter-specific bolts, so check your device’s manual for the thread size and length before you start. Lay out all hardware first; missing bolts are the most common reason a first build stalls.

How do I stop the extended profile from flexing?

Keep the shifter or handbrake mounted as close to the main upright as your reach allows, and use the shortest effective extension. If you need the full 58 cm, add a diagonal brace or support from the rig frame to the free end. Tighten all profile connections firmly, but do not crush the aluminum. Flex is easier to prevent than to fix; plan bracing before you finalize position.

Product facts

• SimXPro X80 + Extended 58 cm Shifter Profile Bundle: Bundles the black SimXPro X80 cockpit (standard pedal deck) with a black 58 cm extended shifter profile. You get a longer mounting arm for shifter or handbrake placement without buying the profile separately.