SimXPro Universal Pedal Plate 420 Installation Guide
By SimXPro l Sim Racing Shop | Published: 2026-10-27
Category: How-to Guides
Learn how to install the SimXPro Universal Pedal Plate 420 with our step-by-step guide. Get a firm, adjustable pedal mount for precise braking and throttle control.
Quick answer
Install the SimXPro Universal Pedal Plate 420 by first dry-fitting the plate to your pedals, then securing it to your cockpit's pedal mount. Use the included mounting hardware and check alignment before tightening to ensure a firm, adjustable setup.
Why a firm pedal plate matters
A flexing pedal plate can make braking feel vague and reduce throttle precision, especially under hard braking. The SimXPro Universal Pedal Plate 420 is designed to create a firm mounting surface, which helps you maintain consistent braking performance lap after lap.
The plate is built for easy adjustment in a cockpit, so you can fine-tune pedal position to match your seating and leg length. This is particularly useful if you share your rig with other drivers or if you're still dialing in your ideal seating position.
Tools and preparation
Before you start, gather the included mounting hardware and a set of hex keys or Allen wrenches that fit your pedal and cockpit bolts. Check that your cockpit's pedal mount area is clean and free of debris to avoid misalignment.
The Universal Pedal Plate 420 is compatible with most pedal sets, but it's always a good idea to verify bolt patterns and spacing before drilling any new holes. If your pedals use a non-standard pattern, you may need additional adapter plates or drilling.
Installation steps
- Dry-fit the plate to your pedals: Place the pedal plate against the underside of your pedals and align the mounting holes. Insert the bolts loosely to confirm the pattern matches. Common mistake: forcing bolts into misaligned holes can strip threads. If the holes don't align, check for adapter plates before drilling.
- Secure the plate to the pedals: Tighten the bolts evenly using a crisscross pattern to avoid warping the plate. Use thread locker if your pedals vibrate. Common mistake: over-tightening can crack the pedal base. Check that the plate sits flat and doesn't rock.
- Mount the assembly to your cockpit: Position the pedal assembly on your cockpit's pedal mount and align with the slots or holes. Insert the mounting hardware and tighten just enough to hold. Common mistake: not centering the pedals can cause an offset driving position. Use a ruler or tape measure to ensure equal distance from the center of the rig.
- Adjust pedal angle and distance: Before final tightening, adjust the pedal plate's angle and fore-aft position to match your seating. Sit in the rig and test the reach. Common mistake: setting the angle too steep can cause ankle strain. Adjust while seated; your knee should be slightly bent at full brake press.
- Tighten all hardware and test: Fully tighten all bolts, then press the pedals firmly to check for any flex or movement. Common mistake: leaving bolts loose can cause the plate to shift during hard braking. Re-check tightness after a few hours of use, as bolts can settle.
Product facts
- SimXPro Universal pedal plate 420 + mounting hardware: The SimXPro Universal pedal plate 420 + mounting hardware creates a firm pedal mounting surface and is designed for easy adjustment in a cockpit. This means you can mount your pedals securely and adjust their position without worrying about flex, which helps you brake more consistently.
SimXPro Universal pedal plate 420 + mounting hardware
